Administrator Guide

in | out | both Enter the keyword in, out, or both to debug incoming interfaces, outgoing
interfaces, or both incoming and outgoing interfaces.
vlan vlan-id Enter the keyword vlan then the VLAN ID. The range is from 1 to 4094.
count value Enter the keyword count then the number of debug outputs. The range is from 1
to 100.
Defaults Debug disabled.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series, E-Series, and E-Series ExaScale.
7.4.1.0 Introduced
protocol-tunnel
Enable protocol tunneling on a stacked (Q-in-Q) VLAN for specified protocol packets.
C9000 Series
Syntax
protocol-tunnel {rate-limit rate| stp}
To disable protocol tunneling for a Layer 2 protocol, use the no protocol-tunnel command.
Parameters
rate-limit rate Enter the keyword rate-limit followed by a number for the rate-limit for
tunneled packets on the VMAN. The range is from 64 to 320.
stp Enter the keyword stp to enable protocol tunneling on a spanning tree, including
STP, MSTP, RSTP, and PVST.
Defaults none
Command Modes CONF-IF-VLAN
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
1594 Service Provider Bridging