Administrator Guide

protocol-tunnel enable
Enable protocol tunneling globally on the system.
C9000 Series
Syntax
protocol-tunnel enable
To disable protocol tunneling, use the no protocol-tunnel enable command.
Defaults Disabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.4.1.0 Introduced
Usage
Information
The system must have the default CAM profile with the default microcode before you enable L2PT.
protocol-tunnel rate-limit
Enable traffic rate limiting per box.
C9000 Series
Syntax
protocol-tunnel rate-limit rate
To reset the rate limit to the default, use the no protocol-tunnel rate-limit rate command.
Parameters
rate Enter the rate in frames per second. The range is from 64 to 320 Kbps.
Defaults no default rate-limit.
Command Modes INTERFACE VLAN
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
1596 Service Provider Bridging