Administrator Guide

● snmp — Enable SNMP notifications defined in RFC 1157.
● stp — Enable notification of a state change in the spanning tree protocol (RFC
1493).
● vlt — Enable notification of VLT state changes.
● vrrp —Enable notification of a state change in a VRRP group.
● xstp — Enable notification of a state change in MSTP (802.1s), RSTP
(802.1w), and PVST+.
notification-
option
For the envmon notification-type, enter one of the following optional parameters:
● cam-utilization
● fan
● supply
● temperature
For the snmp notification-type, enter one of the following optional parameters:
● authentication
● coldstart
● linkdown
● linkup
Defaults Not enabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.1(0.0) Added support for copy-config and ecmp traps.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.4.1.0 Added support for VRRP traps.
7.6.1.0 Added support for STP and xSTP traps. Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
The system supports up to 16 SNMP trap receivers.
For the cam-utilization notification option, the system generates syslogs and SNMP traps when the
L3 host table or route table utilization goes above the threshold.
If you do not configure this command, no traps controlled by this command are sent. If you do not specify
a notification-type and notification-option, all traps are enabled.
Related
Commands
snmp-server community — enables SNMP and sets the community string.
snmp-server host — configures an SNMP trap receiver.
Simple Network Management Protocol (SNMP) and Syslog 1621