Administrator Guide

Version Description
7.5.1.0 Introduced on the C-Series.
snmp-server trap-source
Configure a specific interface as the source for SNMP traffic.
C9000 Series
Syntax
snmp-server trap-source interface
To disable sending traps out a specific interface, use the no snmp trap-source command.
Parameters
interface Enter the following keywords and slot/port or number information:
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults The IP address assigned to the management interface is the default.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
To enable this snmp-server trap-source command, configure an IP address on the interface and
enable the interface configured as an SNMP trap source.
Related
Commands
snmp-server community — sets the community string.
1628 Simple Network Management Protocol (SNMP) and Syslog