Administrator Guide

Related
Commands
show running-config snmp — displays the SNMP running configuration.
snmp-server vrf
Configures an SNMP agent to bind to a specific VRF.
C9000 Series
Syntax
snmp-server vrf vrf-name
To undo the SNMP agent configuration, use the no snmp-server vrf vrf-name command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to associate an SNMP agent
with that VRF.
Defaults default
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S-Series and Z9000.
Usage
Information
Use this command to bind an SNMP agent to a VRF. The SNMP agent processes the requests from the
interfaces that belong to the specified VRF. If no VRF is specified, then the default VRF is used.
Related
Commands
show snmp user — displays the information configured on each SNMP user name.
snmp trap link-status
Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
C9000 Series
Syntax
snmp trap link-status
To disable sending link trap messages, use the no snmp trap link-status command.
Defaults Enabled.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
1632 Simple Network Management Protocol (SNMP) and Syslog