Administrator Guide
logging synchronous
Synchronize unsolicited messages and output.
C9000 Series
Syntax
logging synchronous [level level | all] [limit number-of-buffers]
To disable message synchronization, use the no logging synchronous [level level | all]
[limit number-of-buffers] command.
Parameters
all Enter the keyword all to ensure that all levels are printed asynchronously.
level
level
Enter the keyword level then a number as the severity level. A high number
indicates a low severity level and vice versa. The range is from 0 to 7. The default is
2.
all Enter the keyword all to turn off all.
limit
number-of-
buffers
Enter the keyword limit then the number of buffers to be queued for the
terminal after which new messages are dropped. The range is from 20 to 300. The
default is 20.
Defaults Disabled. If enabled without the level or number-of-buffers options specified, level = 2 and
number-of-buffers = 20 are the defaults.
Command Modes LINE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
When you enable logging synchronous, unsolicited messages appear between software prompts and
outputs. Only the messages with a severity at or below the set level are sent to the console.
If the message queue limit is reached on a terminal line and messages are discarded, a system message
appears on that terminal line. Messages may continue to appear on other terminal lines.
Related
Commands
logging on — enables logging.
logging trap
Specify which messages are logged to the Syslog server based the message severity.
C9000 Series
Syntax
logging trap [level]
To return to the default values, use the default logging trap command.
Simple Network Management Protocol (SNMP) and Syslog 1645