Administrator Guide

Parameters
text Text description of the uplink-state group. The maximum length is 80 alphanumeric
characters.
Defaults none
Command Modes UPLINK-STATE-GROUP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.4.2.3 Introduced on the S-Series S50.
Example
Dell(conf-uplink-state-group-16)# description test
Dell(conf-uplink-state-group-16)#
Related
Commands
uplink-state-group — creates an uplink-state group and enables the tracking of upstream links.
downstream
Assign a port or port-channel to the uplink-state group as a downstream interface.
C9000 Series
Syntax
downstream interface
To delete a downstream interface, enter the no downstream interface command.
Parameters
interface Enter one of the following interface types:
● 10-Gigabit Ethernet: tengigabitethernet {slot/port |slot/port-
range}
● 40-Gigabit Ethernet: fortyGigE {slot/port |slot/port-range}
● Port channel: port-channel {1-512 | port-channel-range}
Where port-range and port-channel-range specify a range of ports
separated by a dash (-) and/or individual ports/port channels in any order; for
example: tengigabitethernet 1/1-2,5,9,11-12 port-channel
1-3,5. A comma is required to separate each port and port-range entry.
Defaults none
Command Modes UPLINK-STATE-GROUP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Uplink Failure Detection (UFD) 1729