Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1731

Command Modes EXEC

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.5(0.1) Introduced on the Z9500.

9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-

Mux (PMUX) mode only.

9.2(0.2) Added multicast and ndp parameters.

9.0.2.0 Introduced on the S6000.

9.0.0.0 Introduced on the Z9000.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

Example

Dell(conf-vlt-domain)#do clear vlt statistics

Sure want to Clear VLT Statistics [confirm] yes

Dell(conf-vlt-domain)#

Commands

show vlt statistics — displays statistics on VLT operations.

delay-restore

Configure the delay in bringing up VLT ports after reload or peer-link restoration between the VLT peer switches.

C9000 Series

Syntax

delay-restore

Parameters

delay-restore Enter the amount of time, in seconds, to delay bringing up the VLT ports after the

VLT device is reloaded or after the peer-link is restored between VLT peer

switches. The range from 1 to 1200. The default is 90 seconds.

Defaults Not configured.

Command Modes VLT DOMAIN