Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1751

Command Modes VLT DOMAIN

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.5(0.1) Introduced on the Z9500.

9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-

Mux (PMUX) mode only.

9.0.2.0 Introduced on the S6000.

9.0.0.0 Introduced on the Z9000.

8.3.19.0 Introduced on the S4820T.

8.3.8.0 Introduced on the S4810.

Usage

Information

When you create a VLT domain on a switch, Dell Networking OS automatically assigns a unique unit ID (0

or 1) to each peer switch. The unit IDs are used for internal system operations. Use the unit-id

command to explicitly configure the unit ID of a VLT peer. Configure a different unit ID (0 or 1) on each

peer switch.

To minimize the time required for the VLT system to determine the unit ID assigned to each peer switch

when one peer reboots, use this command.

vlt domain

Enable VLT on a switch, configure a VLT domain, and enter VLT-domain configuration mode.

C9000 Series

Syntax

vlt domain domain-id

Parameters

domain-id

Enter the Domain ID number. Configure the same domain ID on the peer switch.

The range of domain IDs is from 1 to 1000.

Command Modes CONFIGURATION