Administrator Guide

If you set the priority command to 255 and the virtual-address is not equal to the interface’s
primary IP address, an error message appears.
show config
View the non-default VRRP configuration.
C9000 Series
Syntax
show config [verbose]
Parameters
verbose (OPTIONAL) Enter the keyword verbose to view all VRRP group configuration
information, including defaults.
Command Modes VRRP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
Dell(conf-if-vrid-4)#show con
vrrp-group 4
virtual-address 119.192.182.124
!
show vrrp
View the VRRP groups that are active. If no VRRP groups are active, the Dell Networking OS returns No Active VRRP
group.
C9000 Series
Syntax
show vrrp [vrrp-id] [interface | brief | ipv6 | vrf vrf-name]
Parameters
vrrp-id (OPTIONAL) Enter the Virtual Router Identifier for the VRRP group to view only
that group. The range is from 1 to 255.
interface OPTIONAL) Enter the following keywords and slot/port or number information:
● For Port Channel interface types, enter the keywords port-channel then the
number. The range is from 1 to 128.
Virtual Router Redundancy Protocol (VRRP) 1767