Administrator Guide

● vrrp-ipv6-group
The following commands apply to IPv4 and IPv6:
● advertise-interval
● clear counters vrrp ipv6
● description
● disable
● hold-time
● preempt
● priority
● show config
● virtual-address
clear counters vrrp ipv6
Clear the counters recorded for IPv6 VRRP groups.
C9000 Series
Syntax
clear counters vrrp ipv6 [vrid | vrf instance]
Parameters
vrid (OPTIONAL) Enter the number of an IPv6 VRRP group. The range is from 1 to 255.
vrf instance (OPTIONAL) Enter the name of a VRF instance (32 characters maximum) to clear
the counters of all IPv6 VRRP groups in the specified VRF.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2.(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
8.4.1.0 Introduced on E-Series ExaScale, C-Series, and S-Series. Support was added for
IPv6 VRRP groups in non-default VRF instances.
8.3.2.0 Introduced on the E-Series TeraScale.
debug vrrp ipv6
Enable debugging of VRRP.
C9000 Series
Syntax
debug vrrp ipv6 interface [vrid] {all | packets | state | timer}
Parameters
interface Enter the following keywords and slot/port or number information:
● For a Port Channel interface, enter the keywords port-channel then a
number.
1776 Virtual Router Redundancy Protocol (VRRP)