Administrator Guide

Version Description
8.4.2.1 The range of valid VRID values on the E-Series when VRF microcode is loaded in
CAM changed from 1 to 15.
8.4.1.0 Introduced on the E-Series ExaScale, C-Series, and S-Series.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.2.0 Introduced on the E-Series TeraScale.
Usage
Information
The VRRP group only becomes active and sends VRRP packets when a link-local virtual IP address is
configured. When you delete the virtual address, the VRRP group stops sending VRRP packets.
NOTE: Configure the same VRID on neighboring routers (Dell Networking or non-Dell Networking) in
the same VRRP group in order for all routers to interoperate.
Related
Commands
virtual-address — assigns up to 12 virtual IP addresses per VRRP group.
1780 Virtual Router Redundancy Protocol (VRRP)