Administrator Guide

Version Description
7.6.1.0 Introduced on the C-Series and S-Series.
Usage
Information
Prior to enabling this command, to place the interface in Layer 2 mode, enter the switchport
command.
To remove the access port designation, remove the port (using the no member interface command)
from all stackable VLAN enabled VLANs.
vlan-stack compatible
Enable the stackable VLAN feature on a VLAN.
C9000 Series
Syntax
vlan-stack compatible
To disable the Stackable VLAN feature on a VLAN, use the no vlan-stack compatible command.
Defaults Not configured.
Command Modes CONF-IF-VLAN
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the C-Series and S-Series.
Usage
Information
Prior to disabling the stackable VLAN feature, remove the members.
To view the stackable VLANs, use the show vlan command in EXEC Privilege mode. Stackable VLANs
contain members, designated by the M in the Q column of the command output.
Example
Dell#show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
* 1 Inactive
2 Active M Te 2/13
M Te 2/0-2
3 Active M Po1(Te 2/14-15)
M Te 2/18
M Te 2/3
4 Active M Po1(Te 2/14-15)
M Te 2/18
M Te 2/4
5 Active M Po1(Te 2/14-15)
M Te 2/18
VLAN Stacking 1793