Administrator Guide

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the E-Series ExaScale. C-Series and S-Series accept both bytes of
the 2-byte S-Tag TPID.
8.2.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the C-Series and S-Series.
Usage
Information
For specific interoperability limitations regarding the S-Tag TPID, see the Dell Networking OS
Configuration Guide.
The four characters you enter in the CLI for number are interpreted, as shown in the following table.
Number Resulting TPID
1 0x0001
10 0x0010
81 0x0081
8100 0x8100
Related
Commands
● portmode hybrid — sets a port (physical ports only) to accept both tagged and untagged frames. A
port configured this way is identified as a hybrid port in report displays.
● vlan-stack trunk — specifies a Layer 2 port or port channel as a trunk port to the Stackable VLAN
network.
vlan-stack trunk
Specify a Layer 2 port or port channel as a trunk port to the Stackable VLAN network.
C9000 Series
Syntax
vlan-stack trunk
To remove a trunk port designation from the selected interface, use the no vlan-stack trunk
command.
Defaults Not configured.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Netowrking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
VLAN Stacking 1795