Administrator Guide

rpm slot-id Enter the keyword rpm to upgrade Control and Route processors of the RPM . To
upgrade standby RPM execute the command from primary RPM with rpmA: |
rpmB:,option.
pe pe-id Enter the keyword pe and specify the port extender ID number. The PE ID range is
from 0 to 255. Enter pe all to upgrade all port extenders attached to the C9010.
stack-unit unit-
number
Enter the keyword stack-unit and specify the stack unit number. The stack unit
number range is from 0 to 7.
booted Enter the keyword booted to upgrade C9000 CPUs using the currently loaded
bootflash and bootselector image. This option is not applicable for the system
image.
flash: | ftp: |
tftpdud: |
usbflash: file-url
Enter one of the file transfer methods and locations to specify where the software
image (file-url), which you want to use to upgrade the currently loaded image, is
stored:
● flash://filepath.
● ftp://userid:password@host-ip/filepath to upgrade from an FTP
server, where host-ip is either an IPv4 dotted decimal address or an IPv6
[x:x:x:x::x] format address.
● tftp://host-ip/filepath to upgrade from a TFTP server, where host-
ip is either an IPv4 dotted decimal address or an IPv6 [x:x:x:x::x] format
address.
● usbflash://filepath to upgrade form an external flash device.
rpmA: | rpmB: Specify the primary RPM’s flash partition for upgrade.
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11(0.0) Introduced on N20xx and N30xx series.
9.9 (0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.0(0.0) Added support for IPv6 for the file-url parameter.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000. Added support for the SSD on the Z9000 only.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added support for TFTP and SCP.
7.6.1.0 Introduced on the S-Series.
Usage
Information
A system message displays with status information about the bootflash upgrade.
RFC 3986 specifies that IPv6 host addresses in a uniform resource identifier (URI) must be enclosed in
square brackets, [X:X:X:X::X]. For maximum flexibility, this command accepts IPv6 host addresses with or
without the square brackets.
Reload the system after executing this command.
To upgrade the Dell Networking OS image on a port extender from an attached PE console, enter the
upgrade command in EXEC mode.
In a dual homing setup, you can use this command only from the primary VLT peer.
File Management 191