Administrator Guide

flash:// Enter the location of the OS6 files on a flash drive.
Default None
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11(0.0) Introduced on the C9010
Usage
Information
If you previously installed Dell Networking OS 9.x.x.x on a N20xx or N30xx series device to use it as a port
extender for a C9010, you can use the upgrade system-image-os6 command to install Dell Networking OS
6.x.x.x and use it as a switch.
verify
Validate the software image on the flash drive after the image has been transferred to the system, but before the image has
been installed.
C9000 Series
Syntax
verify { md5 | sha256 }[ flash:// ] img-file [hash-value]
Parameters
md5 Enter the md5 keyword to use the MD5 message-digest algorithm.
sha256
Enter the sha256 keyword to use the SHA256 Secure Hash Algorithm
flash:// (Optional). Enter the flash:// keyword. The default is to use the flash drive. You
can just enter the image file name.
img-file Enter the name the Dell Networking software image file to validate.
hash-value (Optional). Enter the relevant hash published on i-Support.
Default flash drive
Command Modes EXEC mode
Command
History
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Usage
Information
You can enter this command in the following ways:
● verify md5 flash://img-file
● verify md5 flash://img-file <hash-value>
● verify sha256 flash://img-file
● verify sha256 flash://img-file <hash-value>
File Management 193