Administrator Guide

● If sequence-number is configured, the sequence-number is used as a tie breaker for rules with the
same order.
When you use the log option, the CP processor logs detail the packets that match. Depending on how
many packets match the log entry and at what rate, the CP may become busy as it has to log these
packets’ details.
By default, 10 ACL logs are generated if you do not specify the threshold explicitly. The default frequency
at which ACL logs are generated is five minutes. By default, flow-based monitoring is not enabled.
Use the monitor option only when you are using flow-based monitoring. For more information, refer to
the Port Monitoring chapter of the C9000 Series Configuration Guide.
Related
Commands
deny — configures a filter to drop packets.
permit — configures a filter to forward packets.
show ip access-lists
Display inbound or outbound IP access-list information based on a given option.
C9000 Series
Syntax
show ip access-lists {interface interface [in | out]}
Parameters
interface Enter the keyword interface then one of the following keywords and slot/port
or pe-id / stack-unit / port-id information:
● For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet then
the slot/port information.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN interface, enter the keyword vlan then the slot/port number.
● For a Port Channel interface, enter the keyword port-channel then a port
channel number.
● For a port extender Gigabit Ethernet interface, enter the keyword peGigE then
the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255;
the stack-unit unit-number range is from 0 to 7; and the port-id range is from 1
to 48.
● For a port extender 10-Gigabit Ethernet interface, enter the keyword
peTenGigE then the pe-id / stack-unit / port-id information. The pe-id range
is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the port-
id range is 25 to 28 or 49 to 52 depending on the PE.
in Enter the keyword in to display information for an ip ingress or inbound access-list
attached to an interface.
out Enter the keyword out to display information for an ip egress or outbound access-
list attached to an interface.
Defaults None
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Access Control Lists (ACL) 233