Administrator Guide

Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
mac control-plane egress-acl
Enable user egress ACL for L2 control traffic on control plane.
C9000 Series
Syntax
mac control-plane egress-acl
Parameters None
Defaults None
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Error Strings NONE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
Usage
Information
Use this command in Configuration Terminal Batch mode to enable user egress ACL for L2 control traffic
in a dual-homing setup.
mac access-group
Apply a MAC ACL to traffic entering or exiting an interface. You can apply a MAC ACL on a physical, port-channel, or VLAN
interface.
C9000 Series
Syntax
mac access-group access-list-name {in [vlan vlan-range] | out}
To delete a MAC access-group, use the no mac access-group mac-list-name command.
Parameters
access-list-name Enter the name of a configured MAC access list, up to 140 characters.
262 Access Control Lists (ACL)