Administrator Guide

seq
To a deny or permit filter in a MAC access list while creating the filter, assign a sequence number.
C9000 Series
Syntax
seq sequence-number {deny | permit} {any | mac-source-address [mac-source-
address-mask]} [count [byte]] [log [interval minutes] [threshold-in-msgs
[count]] [monitor]
To remove this filter, use the no seq sequence-number command.
Parameters
sequence-
number
Enter a number from 0 to 65535.
deny Enter the keyword deny to configure a filter to drop packets meeting this
condition.
permit Enter the keyword permit to configure a filter to forward packets meeting this
criteria.
any Enter the keyword any to filter all packets.
mac-source-
address
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-
address-mask
(OPTIONAL) Specify which bits in the MAC address must match. If no mask is
specified, a mask of 00:00:00:00:00:00 is applied (in other words, the filter allows
only MAC addresses that match).
count (OPTIONAL) Enter the keyword count to count packets the filter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the filter processes.
log (OPTIONAL) Enter the keyword log to include ACL messages in the log.
threshold-in
msgs count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to
indicate the maximum number of ACL logs that can be generated, exceeding which
the generation of ACL logs is terminated with the seq, permit, or deny
commands. The threshold range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes
at which ACL logs must be generated. The threshold range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic
that you want to monitor and the ACL in which you are creating the rule is applied
to the monitored interface. For more information, refer to the “Flow-based
Monitoring” section in the Port Monitoring chapter of the Dell Networking OS
Configuration Guide.
Defaults Not configured
Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
270 Access Control Lists (ACL)