Administrator Guide

To disable, use the debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-
group-name] soft-reconfiguration command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to enable
soft-reconfiguration debugging on that VRF.
A.B.C.D (OPTIONAL) Enter the IPv4 address of the neighbor in dotted decimal format.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group-name (OPTIONAL) Enter the name of the peer group to disable or enable all routers
within the peer group..
Defaults Disabled
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced.
Usage
Information
This command turns on BGP soft-reconfiguration inbound debugging. If no neighbor is specified, debug
turns on for all neighbors.
debug ip bgp updates
View information about BGP updates.
C9000 Series
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group peer-group-
name] updates [in | out | prefix-list prefix-list-name]
To disable debugging, use the no debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X
| peer-group peer-group-name] updates [in | out | prefix-list prefix-list-
name] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to view BGP
updates information corresponding to that VRF.
A.B.C.D (OPTIONAL) Enter an IPv4 address of the neighbor.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
356 Border Gateway Protocol