Administrator Guide

peer-group peer-
group-name
(OPTIONAL) Enter the keyword peer-group followed by the name of the peer
group.
in (OPTIONAL) Enter the keyword in to view only BGP updates received from
neighbors.
out (OPTIONAL) Enter the keyword out to view only BGP updates sent to neighbors.
prefix-list prefix-
list-name
(OPTIONAL) Enter the keyword prefix-list then the name of an established
prefix list. If the prefix list is not configured, the default is permit (to allow all
routes).
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group-name (OPTIONAL) Enter the name of the peer group to disable or enable all routers
within the peer group.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
To remove all configured debug commands for BGP, enter the no debug ip bgp command.
default-metric
Allows you to change the metric of redistributed routes to locally originated routes. Use this command with the redistribute
command.
C9000 Series
Syntax
default-metric number
To return to the default setting, use the no default-metric command.
Parameters
number Enter a number as the metric to be assigned to routes from other protocols. The
range is from 1 to 4294967295.
Defaults 0
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Border Gateway Protocol 357