Administrator Guide

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
At least one interface must be in Layer 3 mode for the router bgp command to be accepted. If all
interfaces are configured under VRF, at least one interface should be in the default VRF for the router
bgp command to be accepted. If no interfaces are enabled for Layer 3, an error message appears:
% Error: No router id
configured
BGP does not allow 23456 (AS-TRANS) as a configured AS number.
Example
DellEMC(conf)# router bgp 3
DellEMC(conf-router_bgp)#
set extcommunity bandwidth
Set extended community bandwidth for handling inbound and outbound policies.
Syntax
set extcommunity bandwidth
To disable extended community bandwidth, enter the no set extcommunity bandwidth command.
Parameters
bandwidth Enter the keyword bandwidth to enable extended community bandwidth. The
range is from 0 to 102400.
Defaults N/A
Command Modes ROUTER MAP
Command
History
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S-Series.
Usage
Information
A new policy command is introduced in order to attach the Link Bandwidth extended community only to
the prefixes that are received from a neighbor that satisfy the desired conditions. This command is
relevant for both inbound as well as outbound policy handling (for received prefixes). Also, there is no
change to the set of supported conditions or filters.
During configuration, the bandwidth is specified in Mbps, not in bytes/second. While creating the actual
LB extended community, the system will attach the AS number and encode the bandwidth in floating
point format.
390 Border Gateway Protocol