Administrator Guide

cam-acl (Configuration)
Select the default CAM allocation settings or reconfigure a new CAM allocation for Layer 2, IPv4, and IPv6 ACLs, Layer 2 and
Layer 3 (IPv4) QoS, Layer 2 Protocol Tunneling (L2PT), IP and MAC source address validation for DHCP, Ethernet Connectivity
Fault Management (CFM) ACLs, OpenFlow, and Policy-based Routing (PBR).
C9000 Series
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos
number l2qos number l2pt number ipmacacl number [vman-qos | vman-dual-qos
number] ecfmacl number [nlbclusteracl number] ipv4pbr number }openflow
number | fcoe number} [iscsioptacl number] [vrfv4acl number]
Parameters
default Use the default CAM profile settings and set the CAM as follows:
● L2Acl : 5
● IPV4Acl : 4
● IPV6Acl : 0
● IPV4Qos : 2
● L2Qos : 1
● L2PT : 0
● IpMacAcl : 0
● VmanQos : 0
● VmanDualQos : 0
● EcfmAcl : 0
● nlbclusteracl: 0
● FcoeAcl : 0
● iscsiOptAcl : 0
● ipv4pbr : 0
● Openflow : 0
● fedgovacl : 0
● vrfv4Acl : 0
l2acl number Enter the keyword l2acl and then the number of l2acl blocks. The range is from 1
to 8.
ipv4acl number Enter the keyword ipv4acl and then the number of FP blocks for IPv4. The range
is from 0 to 8.
ipv6acl number Enter the keyword ipv6acl and then the number of FP blocks for IPv6. The range
is from 0 to 2.
ipv4qos number Enter the keyword ipv4qos and then the number of FP blocks for IPv4. The
range is from 0 to 8.
l2qos number Enter the keyword l2qos and then the number of FP blocks for l2 qos. The range
is from 1to 8.
l2pt number Enter the keyword l2pt and then the number of FP blocks for l2 protocol
tunnelling. The range is from 0 to 1.
Ipmacacl number Enter the keyword ipmacacl and then the number of FP blocks for IP and MAC
ACL. The range is from 0 to 6.
ecfmacl number Enter the keyword ecfmacacl and then the number of FP blocks for ECFM ACL.
The range is from 0 to 5.
nlbclusteracl
number
Enter the keyword nlbclusteracl and then the number of FP blocks for
nlbcluster ACL. The range is from 0 to 2. By default the value is 0 and it supports 8
NLB arp entries reserved for internal functionality.
Vman-qos|vman-
dual-qos number
Enter the keyword evman-qos and then the number of FP blocks for VMAN QoS.
The range is from 0 to 6.
Content Addressable Memory (CAM) 499