Administrator Guide

Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
Usage
Information
To display the per-protocol counters of rate-limited control-plane traffic at the aggregated (switch) or
line card and port set level, use the show control-traffic protocol command.
clear control-traffic queue
Clear per-queue counters of rate-limited control-plane traffic.
C9000 Series
Syntax
clear contol—traffic queue {all | queue-number} counters
Parameters
all Enter the keyword all to clear counters for rate-limited traffic on all CPU queues,
including Route Processor, Control Processor, and line-card CPUs.
queue-number Enter the queue number to clear counters for rate-limited traffic on a specified
CPU queue. The range of queue-number values is from 0 to 20. The twenty-one
control–plane queues are divided into groups of seven queues for the Route
Processor, Control Processor, and line-card CPUs as follows:
● Queues 0 to 6 process packets destined to the Control Processor CPU .
● Queues 7 to 13 process packets destined to the Route Processor CPU.
● Queues 14 to 20 process packets destined to the line card CPU.
Defaults Clear per-queue rate-limiting counters for all control-plane and port traffic.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
Usage
Information
To display the per-queue counters of rate-limited control-plane traffic at the aggregated (switch), use
the show control-traffic queue command.
Control Plane Policing (CoPP) 513