Administrator Guide

Defaults None
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
Usage
Information
In the show output, Rx Bytes displays the number of bytes of control-plane traffic received, on which
queue-based rate limiting is applied. Tx Counters displays the number of bytes transmitted to a control-
plane CPU after queue-based rate limiting is applied. Drop Counters displays the number of bytes of
control-plane traffic that have been dropped as a result of queue-based rate limiting.
To clear the per-queue counters of rate-limited control-plane traffic at the aggregated (switch), use the
clear control-traffic queue command.
Example
Dell#show control-traffic queue queue-id 0 counters
Queue Rx Counter Tx Counter Drop counter
---------------------------------------------------------
Q0 5000 5000 0
Dell#
Related
Command
clear control-traffic queue
show cpu-queue rate
Display the rates for each control-plane queue.
C9000 Series
Syntax
show cpu-queue rate [all | queue-id queue-number | range from_queue
to_queue]
Parameters
all Display the rate for all control-plane queues. The CPU queues range is from 0 to
20.
queue-id queue-
number
Display the rate for a specified control-plane queue. The CPU queue value range is
from 0 to 20.
range
from_queue
to_queue
Display the rate for a range of control-plane queues. The CPU queue value range is
from 0 to 20. Separate the from_queue value from the to_queue value with a
space; for example, show cpu-queue rate range 8 15.
Defaults Not configured.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
518 Control Plane Policing (CoPP)