Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

531

532

533

534

535

536

537

538

539

540

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.

Usage

Information

NOTE: Please note that Dell Networking do not recommend to use this command as it has been

deprecated in the current 9.4.(0.0) release. A warning message appears when you try to run this

command indicating that you have to use the dcb-map commands in the future.

You can enable any number of 802.1p priorities for PFC. Queues to which PFC priority traffic is mapped

are lossless by default. Traffic may be interrupted due to an interface flap (going down and coming up)

when you reconfigure the lossless queues for no-drop priorities in a PFC input policy and reapply the

policy to an interface.

The maximum number of lossless queues supported on the switch is two.

A PFC peer must support the configured priority traffic (as DCBX detects) to apply PFC.

show dcb

Display the data center bridging status, the number of PFC-enabled ports, and the number of PFC-enabled queues.

C9000 Series

Syntax

show dcb [stack-unit unit-number] [port-set port-set-number]

Parameters

unit-number

Enter the DCB unit number.

port-set-number

Enter the port-set number.

Command Modes EXEC Privilege