Administrator Guide

Te 10/0 P2 0 0 0
Te 10/0 P3 0 0 0
Te 10/0 P4 0 0 0
Te 10/0 P5 0 0 0
Te 10/0 P6 0 0 0
Te 10/0 P7 0 0 0
Interface TenGigabitEthernet 10/1
Interface Priority Rx XOFF Frames Rx Total Frames Tx Total Frames
------------------------------------------------------------------------
Te 10/1 P0 0 0 0
Te 10/1 P1 0 0 0
Te 10/1 P2 0 0 0
Te 10/1 P3 0 0 0
Te 10/1 P4 0 0 0
Te 10/1 P5 0 0 0
Te 10/1 P6 0 0 0
Te 10/1 P7 0 0 0
ETS Commands
The following ETS commands are supported on the Dell Networking OS.
dcb-enable
Enable data center bridging.
C9000 Series
Syntax
dcb enable[pfc-queues 1|4]
To disable DCB, use the no dcb enable command.
Parameters
pfc-queues Enter the pfc-queue range. To disable DCB, use the no dcb enable command. The
range is from 1 or 2.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Version
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.1) Introduced on the S3048-ON and S4048-ON .
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Data Center Bridging (DCB) 539