Administrator Guide

debug dcbx
Enable DCBX debugging.
Syntax
debug dcbx {all | auto-detect-timer | config-exchng | fail | mgmt |
resource | sem | tlv}
To disable DCBX debugging, use the no debug dcbx command.
Parameters
{all | auto-
detect-timer |
config-exchng |
fail | mgmt |
resource | sem |
tlv}
Enter the type of debugging, where:
● all: enables all DCBX debugging operations.
● auto-detect-timer: enables traces for DCBX auto-detect timers.
● config-exchng: enables traces for DCBX configuration exchanges.
● fail: enables traces for DCBX failures.
● mgmt: enables traces for DCBX management frames.
● resource: enables traces for DCBX system resource frames.
● sem: enables traces for the DCBX state machine.
● tlv: enables traces for DCBX TLVs.
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010 .
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
fcoe priority-bits
Configure the FCoE priority advertised for the FCoE protocol in application priority TLVs.
C9000 Series
Syntax
fcoe priority-bits priority-bitmap
To remove the configured FCoE priority, use the no fcoe priority-bits command.
Parameters
priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.
Defaults 0x8
Command Modes PROTOCOL LLDP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Data Center Bridging (DCB) 551