Manualshelf

Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch
51525354555657585960
To enter VRRP mode:
1. To enable VRRP globally, verify that you are logged in to CONFIGURATION mode.
2. Enter the vrrp-group command then enter the VRRP group ID. The prompt changes to include (conf-if-interface-type-
slot/port-vrid-vrrp-group-id).
UPLINK STATE GROUP Mode
To enable and configure an uplink-state group, use UPLINK STATE GROUP mode. For more information, see Uplink Failure
Detection (UFD).
To enter UPLINK STATE GROUP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the uplink-state-group command then the group ID number. The prompt changes to include (conf-uplink-state-
group-groupID).
58 CLI Basics