Administrator Guide

● port port-num statistics: Clears statistics on a specified party-bus
internal port.
● port all: Clear statistics on all party-bus internal ports.
pe pe-id Enter the keyword pe with a port extender (PE) ID to clear hardware statistics for
a specified port extender. The PE ID range is from 0 to 255.
NOTE: The pe option is only visible when the extended bridge feature is
enabled.
stack-unit unit-
number
Enter the keyword stack-unit with a stack unit number to clear hardware
statistics for a specified stack-unit number. The stack-unit number range is from 0
to 7.
rp Enter the keyword rp with a command option to clear hardware statistics for the
Route Processor. The command options are:
● cpu data-plane statistics: Clears data-plane statistics, including the
HiGig port statistics with input/output counters.
● cpu i2c statistics: Clears active i2c-address statistics.
● cpu sata-interface statistics: Clears sata-interface error counter
statistics.
sfm sfm-unit-
num
Enter the keyword sfm with a Switch Fabric Module (SFM) unit number and a
command option to clear hardware statistics from the specified SFM. The range of
SFM unit numbers is from 0 to 5. The command options are:
● counters: Clears the traffic counters.
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.0 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
Related
Commands
show hardware — displays the data plane or management plane input and output statistics of the
designated component of the designated stack member.
clear hardware system-flow
Clear system-flow statistics from a specified line card.
C9000 Series
Syntax
clear hardware system-flow {cp-switch | linecard slot-id | pe pe-id stack-
unit unit-number} [port-set port-pipe counters]
590 Debugging and Diagnostics