Administrator Guide
Parameters
linecard
slot-id
Enter the linecard slot-id parameters to identify the line card on which you
want to clear system-flow statistics. The range of slot IDs is from 0 to 11.
pe
pe-id
Enter the pe pe-id parameters to specify the port extender ID for which you
want to clear system-flow statistics.
NOTE: The pe option is only visible when the extended bridge feature is
enabled.
stack-unit
unit-
number
Enter the stack—unit unit—number parameters to specify the stack-unit for
which you want to clear system-flow statistics.
port-set
port-
pipe
counters
Enter the keywords port-set along with a port-pipe number, then the keyword
counters to clear the system-flow counters on the selected port-pipe. The range of
port-pipe numbers is: 0 to 2 on line card 0 and 0 to 3 on line cards 1 and 2.
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.0 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
Related
Commands
show hardware — displays the data plane or management plane input and output statistics for a specified
hardware component.
remote-exec
Debug and troubleshoot switch hardware using remote commands.
NOTE: Use the remote-exec command only with the guidance of an engineer from Dell Networking Technical Support.
C9000 Series
Syntax
remote-exec {cp | rp | linecard slot-id} hw-command
Parameters
cp Enter the keyword cp to troubleshoot Control Processor CPU operation.
rp Enter the keyword rp to troubleshoot Route Processor CPU operation.
linecard
slot-id
Enter the linecard slot-id to troubleshoot line-card CPU operation. The
range of line-card slot IDs is from 0 to 11. Each line-card CPU processes packets on
the corresponding line card on your switch.
hw-command
Enter the debug command that Dell Networking Technical Support gives you.
Defaults none
Command Modes
● EXEC
● EXEC Privilege
Debugging and Diagnostics 591