Administrator Guide

show hardware ip
Display Layer 3 ACL or QoS data for a line card and port pipe.
C9000 Series
Syntax
show hardware ip {eg-acl | in-acl | qos} linecard slot-id | pe pe-id stack-
unit unit-number port-set port-pipe
Parameters
eg-acl Enter the keyword eg-acl to display Layer 3 egress acl data.
in-acl Enter the keyword in-acl to display Layer 3 ingress acl data.
qos Enter the keyword qos to display QoS data.
linecard slot-id Enter the linecard slot-id parameters to specify a line card. The range of
slot IDs is from 0 to 11.
pe pe-id Enter the keyword pe and the port extender ID. The range is from 0 to 255.
NOTE: The pe option is only visible when the feature extended bridge feature
is enabled.
stack-unit unit-
number
Enter the keyword stack-unit and the stack unit number. The range is from 0 to
7.
port-set port-
pipe
Enter the keywords port-set port-pipe parameters to specify a port pipe
(set of ports) on a line card. The range of port-pipe numbers is 0.
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.0 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
Example
Dell#show hardware ip eg-acl linecard 0 port-set 0
EID 0x000011b9: gid=0xf,
slice=2, slice_idx=0, part =0 prio=0x11b9, flags=0x10202,
Installed, Enabled
tcam: color_indep=0,
StageEgress
Color
Offset: 5 Width: 2
DATA=0x00000001
MASK=0x00000003
action={act=RpDrop, param0=0(0), param1=0(0), param2=0(0),
param3=0(0)}
policer=
statistics={stat id 64 slice = 2 idx=1 entries=1}{Packets}
EID 0x000011b8: gid=0xf,
slice=2, slice_idx=0x1, part =0 prio=0x11b8, flags=0x10202,
608 Debugging and Diagnostics