Administrator Guide

Stage
SrcIp
Offset: 153 Width: 32
DATA=0x02020201
MASK=0xffffffff
action={act=CopyToCpuCancel, param0=0(0), param1=0(0),
param2=0(0), param3=0(0)}
action={act=EtagNew, param0=327687(0x50007), param1=0(0),
param2=0(0), param3=0(0)}
policer=
statistics={stat id 166 slice = 5 idx=0 entries=1}{Packets}
EID 0x00000e01: gid=0x2,
slice=1, slice_idx=0, part =0 prio=0xe01, flags=0x10602,
Installed, Enabled
tcam: color_indep=1024,
IpType
Offset: 325 Width: 4
DATA=0x00000000
MASK=0x0000000e
InPort
DATA=0x0000000000000000000000000000000000000000000000000000000000000004
MASK=0x00000000000000000000000000000000000000000000000000fdffffffffffff
InPorts
DATA=0x0000000000000000000000000000000000000000000000000000000000000004
MASK=0x00000000000000000000000000000000000000000000000000fdffffffffffff
HiGig
Offset: 320 Width: 1
DATA=0x00000000
MASK=0x00000001
Stage
IpFrag
Offset: 71 Width: 2
DATA=0x00000001
MASK=0x00000001
action={act=CopyToCpuCancel, param0=0(0), param1=0(0),
param2=0(0), param3=0(0)}
action={act=EtagNew, param0=327687(0x50007), param1=0(0),
param2=0(0), param3=0(0)}
policer=
statistics={stat id 167 slice = 6 idx=0 entries=1}{Packets}
show hardware ipv6
Display information about IPv6 ACLs used on a line card and port pipe.
C9000 Series
Syntax
show hardware ipv6 {eg-acl | in-acl} linecard slot-id port-set port-pipe
Parameters
eg-acl | in-acl Enter either the keyword eg-acl or the keyword in-acl to display ingress or
egress ACL data.
linecard slot-id Enter the linecard slot-id parameters to specify a line card on the switch.
The range of slot IDs is from 0 to 2.
port-set port-
pipe
Enter the keywords port-set port-pipe parameters to specify a port pipe
(set of ports) on a line card. The range of port-pipe numbers is: 0 to 2 on line card
0 and 0 to 3 on line cards 1 and 2.
Defaults none
610 Debugging and Diagnostics