Administrator Guide

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and S-Series.
host-address
For manual (rather than automatic) configurations, assign a host to a single-address pool.
Syntax
host—address address
Parameters
address Enter the host IP address.
Defaults None
Command Modes DHCP-POOL
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14.1.3 This command replaces host command. Introduced on S3048–ON, S4048–ON,
S4048T-ON, S6000–ON, S6010–ON, S6100–ON, Z9100–ON, S3100, S6000,
S4810, S4820T, S5048F-ON, MXL, FN-IOM, and C9010.
Usage
Information
When you upgrade the Dell EMC Networking OS from an earlier version to 9.14.1.3 or later, the system
converts the DHCP CONFIGURATION host command in the running configuration to the host-
address command. If you downgrade the Dell EMC Networking OS from version 9.14.1.3 or later to an
earlier version, any existing host-address command is deleted from the running configuration. If you
want to create manual DHCP bindings, use the host command.
ip address dhcp
Configure an interface to receive its IP address from the configured DHCP server.
C9000 Series
Syntax
ip address dhcp
To release the IP address acquired from a DHCP server, enter the no ip address dhcp command.
Defaults Not configured.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Dynamic Host Configuration Protocol (DHCP) 625