Administrator Guide
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Added support for the fcoe parameter on the S4810 and S4820T.
9.1.(0.0) Added support for OpenFlow on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Added the keywords fcoeacl and iscsioptacl on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage
Information
For the new settings to take effect, save the new CAM settings to the startup-config (write-mem or
copy run start) then reload the system.
The total amount of space allowed is 16 FP Blocks. System flow requires four blocks and these blocks
cannot be reallocated. The total number of blocks must be equal to 12. The ipv4acl profile range is from
0 to 8.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 12.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which is from 0 to 10. The
ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
If you enabled BMP 3.0, to perform a reload on the chassis to upgrade any configuration changes that
have changed the NVRAM content, use the reload conditional nvram-cfg-change command.
You can use the cam-acl default command in Configuration Terminal Batch mode to reset ACL CAM
entries to default settings in a dual-homing setup.
cam-audit linecard
Enable audit of the IPv4 forwarding table on all line cards.
C9000 Series
Syntax
cam-audit linecard all ipv4-fib interval time-in-minutes
Parameters
all Enter the keyword all to enable CAM audit on all line cards.
ipv4-fib Enter the keyword ipv4-fib to designate the CAM audit on the IPv4 forwarding
entries.
interval
time-in-
minutes
Enter the keyword interval followed by the frequency in minutes of the CAM
audit. Range: 5 to 1440 minutes (24 hours). Default: 60 minutes.
Defaults Disabled
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command
History
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
66 Control and Monitoring