Administrator Guide

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(0.2) Introduced on the S4810 and S4820T.
fip-snooping port-mode fcf
Configure the port for bridge-to-FCF links.
C9000 Series
Syntax
fip-snooping port-mode fcf
To disable the bridge-to-FCF link on a port, use the no fip-snooping port-mode fcf command.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
Usage
Information
The maximum number of FCFs supported per FIP snooping-enabled VLAN is twelve.
NOTE: The fip-snooping port-mode fcf command is not supported on cascade interfaces or
extended ports.
fip-snooping port-mode fcoe-trusted
Configure the port for bridge-to-bridge links.
C9000 Series
Syntax
fip-snooping port-mode fcoe-trusted
To remove the bridge-to-bridge link configuration from the port, use the no fip-snooping port-
mode fcoe-trusted command.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
8.3.19.0 Introduced on the S4820T.
662 FCoE Transit