Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

671

672

673

674

675

676

677

678

679

680

Commands

ip ssh server Configure an SSH server.

show ip ssh

client-pub-keys

Display the client-public keys.

Usage

Information

Both inbound and outbound SSH sessions using IPv4 or IPv6 addressing are supported. Inbound SSH

supports accessing the system through the management interface as well as through a physical Layer 3

interface.

NOTE: Some of the parameters in this command require licensing to access. For more information,

contact your Dell Networking representative.

Example

If FIPS mode is not enabled:

Dell#ssh 10.11.8.12 ?

-c Encryption cipher to use (for v2 clients only)

-l User name option

-m HMAC algorithm to use (for v2 clients only)

-p SSH server port option (default 22)

-v SSH protocol version

<cr>

Dell#ssh 10.11.8.12 -c ?

3des-cbc Force ssh to use 3des-cbc encryption cipher

aes128-cbc Force ssh to use aes128-cbc encryption cipher

aes192-cbc Force ssh to use aes192-cbc encryption cipher

aes256-cbc Force ssh to use aes256-cbc encryption cipher

aes128-ctr Force ssh to use aes128-ctr encryption cipher

aes192-ctr Force ssh to use aes192-ctr encryption cipher

aes256-ctr Force ssh to use aes256-ctr encryption cipher

Dell#ssh 10.11.8.12 -m ?

hmac-md5 Force ssh to use hmac-md5 HMAC algorithm

hmac-md5-96 Force ssh to use hmac-md5-96 HMAC algorithm

hmac-sha1 Force ssh to use hmac-sha1 HMAC algorithm

hmac-sha1-96 Force ssh to use hmac-sha1-96 HMAC algorithm

hmac-sha2-256 Force ssh to use hmac-sha2-256 HMAC algorithm

With FIPS mode enabled: