Administrator Guide

Related
Commands
gvrp enable — enables GVRP on physical interfaces and LAGs.
protocol gvrp — access GVRP protocol.
garp timers
Set the intervals (in milliseconds) for sending GARP messages.
C9000 Series
Syntax
garp timers {join | leave | leave-all}
To return to the previous setting, use the no garp timers {join | leave | leave-all}
command.
Parameters
join Enter the keyword join then the number of milliseconds to configure the join
time. The range is from 100 to 147483647 milliseconds. The default is 200
milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
leave Enter the keyword leave then the number of milliseconds to configure the leave
time. The range is from 100 to 2147483647 milliseconds. The default is 600
milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
leave-all Enter the keywords leave-all then the number of milliseconds to configure the
leave-all time. The range is from 100 to 2147483647 milliseconds. The default is
1000 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
Defaults As above.
Command Modes CONFIGURATION-GVRP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on C-Series, E-Series, and S-Series
Usage
Information
● Join Timer — Join messages announce the willingness to register some attributes with other
participants. For reliability, each GARP application entity sends a Join message twice and uses a join
timer to set the sending interval.
● Leave Timer — Leave announces the willingness to de-register with other participants. Together
with Join, Leave messages help GARP participants complete attribute reregistration and de-
registration. The leave timer starts after receipt of a leave message sent for de-registering some
attribute information. If a Join message is not received before the Leave time expires, the GARP
application entity removes the attribute information as requested.
GARP VLAN Registration (GVRP) 691