Administrator Guide

Version Description
8.3.12.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the E-Series
Usage
Information
If you disable auto failover, enter the redundancy auto-failover-limit (without any parameters)
to set auto failover to the default parameters (Count 3, Period 60 minutes). To view the redundancy
status, use the show redundancy command.
When you change one or both of the optional parameters, Dell Networking OS checks that the interval
between auto failovers is more than five (5) minutes. If the interval is less, Dell Networking OS returns a
configuration error message.
redundancy disable-auto-reboot
Prevent the system from auto-rebooting the failed module.
C9000 Series
Syntax
redundancy disable-auto-reboot {linecard [slot—id | all] | pe pe-id stack
unit unit-number | all | rpm}
Parameters
lincard slot-id /
all
Enter the keyword linecard with the slot-id to specify a linecard, or all to
select all linecards. Linecard ID. Range is from 0 to 11.
pe pe-id / all Enter the keyword pe and the port extender ID or type the option all to select all
port extenders. Range is from 0 to 255.
stack unit unit-
number
Enter the keyword stack-unit and the configuration is applied to all the stack-
units present in the PE.
rpm Enter the keyword rpm to disable auto-reboot of the failed RPM.
Default Disabled (that is, the failed module is automatically rebooted).
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Added the all option.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the E-Series
High Availability (HA) 699