Administrator Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the E-Series.
Example
Dell#redundancy reset-counter pe 1
redundancy synchronize
Manually synchronize data between the RPMs and PEs at any time.
C9000 Series
Syntax
redundancy synchronize [full]
Parameters
full Enter the keyword full to synchronize all data.
Default Not configured.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the E-Series.
Data between the two RPMs or PEs is synchronized immediately after bootup. Once the two RPMs or
PEs complete an initial full synchronization (block sync), the Dell Networking OS updates changed data
(incremental sync).The data that is synchronized consists of configuration data, operational data, state
and status, and statistics depending on the Dell Networking OS version.
show redundancy
Display the current redundancy configuration.
C9000 Series
Syntax
show redundancy pe pe-id
702 High Availability (HA)