Administrator Guide

Interfaces
The Dell Networking OS supports the interface configuration commands described in this chapter.
This chapter contains the following sections:
● Basic Interface Commands
● EIS Commands
● Port Channel Commands
● High-Gigabit Port Channel Commands
Topics:
• Basic Interface Commands
• Egress Interface Selection (EIS) Commands
• Port Channel Commands
• HiGig Port Channel Commands
• Time Domain Reflectometer (TDR) Commands
Basic Interface Commands
The following commands are for Physical, Loopback, and Null interfaces.
clear counters
Clear the counters used in the show interfaces commands for all virtual router redundancy protocol (VRRP) groups, virtual local
area networks (VLANs), and physical interfaces, or selected ones.
C9000 Series
Syntax
clear counters [interface] [vrrp [ipv6 {vrid} | learning-limit | vlan vlan-
id]
Parameters
interface (OPTIONAL) Enter any of the following keywords and slot/port, pe-id/stack-unit/
port or number to clear counters from a specified interface:
● For IPv4 access-group counters, enter the keyword ip.
● For IPv6 access-group counters, enter the keyword ipv6.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For MAC access-group counters, enter the keyword mac.
● For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then
the slot/port (ports, port-range) information.
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 4096.
● For the management interface on the RPM, enter the keyword
ManagementEthernet then slot/port information. The slot range is from 0 to
1 and the port range is 0.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port (ports, port-range) information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port (range of ports) information.
22
708 Interfaces