Administrator Guide
● Do not enable tx pause when buffer carving is enabled. For information and assistance, consult Dell
Networking TAC.
● Asymmetric flow control (rx on tx off, or rx off tx on) setting for the interface port less
than 100 Mb/s speed is not permitted. The following error is returned:
Can’t configure Asymmetric flowcontrol when speed <1G, config ignored
● The only configuration applicable to half duplex ports is rx off tx off. The following error is
returned:
Can’t configure flowcontrol when half duplex is configure, config ignored
● Half duplex cannot be configured when the flow control configuration is on (default is rx on tx
on). The following error is returned:
Can’t configure half duplex when flowcontrol is on, config ignored
NOTE: The flow control must be off (rx off tx off) before configuring the half duplex.
NOTE: If you use the disable rx flow control command, Dell Networking recommends
rebooting the system.
NOTE: The flow control feature is not supported on the Port Extender Gigabit Ethernet (peGigE)
interface.
Example
Dell(conf-if-te-0/1)# show config
!
interface TengigabitEthernet 0/1
no ip address
switchport
no negotiation auto
flowcontrol rx off tx on monitor 9
no shutdown
...
Related
Commands
● show running-config — displays the flow configuration parameters (non-default values only).
● show interfaces — displays the negotiated flow control parameters.
interface
Configure a physical or logical interfaces on the switch.
C9000 Series
Syntax
interface interface range [group interface]
Parameters
interface
Enter one of the following keywords and slot/port, pe-id /stack-unit or number
information:
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then
the slot/port information.
● For a Loopback interface, enter the keyword loopback then the slot/port
information. The range is from 0 to 16383.
● For a Management Ethernet interface, enter the keyword
managementethernet then the slot/port information.
● For a null interface, enter the keyword null then the slot/port information.
The Null interface number is 0.
718 Interfaces