Administrator Guide
Usage
Information
When you enable this feature, it allows you to set the delay timer value between 1 second to 300 seconds
on all ports globally.
To disable the timer on all ports, use the no port-delay-restore command.
To disable the timer on an individual interface, use the no port-delay-restore command in the
INTERFACE mode.
NOTE:
● This command does not work on the Port Extender ports.
● With line cards, the port-delay-restore timer kicks in for each individual line card separately as it
boots up.
Related
Commands
no port-delay-restore (Interface Mode) — disables delayed bring up of individual interfaces
during switch boot up.
portmode hybrid
To accept both tagged and untagged frames, set a physical port or port-channel. A port configured this way is identified as a
hybrid port in report displays.
C9000 Series
Syntax
portmode hybrid
To return a port to accept either tagged or untagged frames (non-hybrid), use the no portmode
hybrid command.
Defaults non-hybrid
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
The following describes the interface command shown in the following example. This example sets a
port as hybrid, makes the port a tagged member of VLAN 20, and an untagged member of VLAN 10,
which becomes the native VLAN of the port. The port now accepts:
● untagged frames and classify them as VLAN 10 frames
● VLAN 20 tagged frames
The following describes the do show interfaces command shown in the following example. This
example shows output with “Hybrid” as the newly added value for 802.1QTagged. The options for this
field are:
736 Interfaces