Administrator Guide

● True — port is tagged
● False — port is untagged
● Hybrid — port accepts both tagged and untagged frames
The following describes the interface vlan command shown in the following example. This example
shows unconfiguration of the hybrid port using the no portmode hybrid command.
NOTE: Remove all other configurations on the port before you can remove the hybrid configuration
from the port.
Example
Dell(conf)# interface te 2/0
Dell(conf-if-te-2/0)# portmode hybrid
Dell(conf-if-te-2/0)# interface vlan 10
Dell(conf-if-vl-10)# untagged te 2/0
Dell(conf-if-vl-10)# interface vlan 20
Dell(conf-if-vl-20)# tagged te 2/0
Dell(conf-if-vl-20)#
Example
Dell(conf-if-vl-20)# do show interfaces switchport
Name: TenGigabitEthernet 2/0
802.1QTagged: Hybrid
Vlan membership:
Vlan 10, Vlan 20
Native VlanId: 10
Dell(conf-if-vl-20)#
Example (Vlan)
Dell(conf-if-vl-20)# interface vlan 10
Dell(conf-if-vl-10)# no untagged te 2/0
Dell(conf-if-vl-10)# interface vlan 20
Dell(conf-if-vl-20)# no tagged te 2/0
Dell(conf-if-vl-20)# interface te 2/0
Dell(conf-if-te-2/0)# no portmode hybrid
Dell(conf-if-vl-20)#
Related
Commands
● show interfaces switchport — displays the configuration of switchport (Layer 2) interfaces on the
switch.
● switchport — places the interface in a Layer 2 mode.
● vlan-stack trunk — specifies an interface as a trunk port to the Stackable VLAN network.
rate-interval
Configure the traffic sampling interval on the selected interface.
C9000 Series
Syntax
rate-interval seconds
Parameters
seconds Enter the number of seconds for which to collect traffic data. The range is from 5
to 299 seconds.
NOTE: Because polling occurs every 15 seconds, the number of seconds
designated here rounds to the multiple of 15 seconds lower than the entered
value. For example, if 44 seconds is designated, it rounds to 30; 45 to 59
seconds rounds to 45.
Defaults 299 seconds
Command Modes INTERFACE
Interfaces 737