Administrator Guide

enable optic-info-update interval
Enable polling intervals of optical information updates for simple network management protocol (SNMP).
C9000 Series
Syntax
enable optical-info-update interval seconds
To disable optical power information updates, use the no enable optical-info-update
interval command.
Parameters
interval seconds Enter the keyword interval then the polling interval in seconds. The range is
from 120 to 6000 seconds. The default is 300 seconds (5 minutes).
Defaults Disabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Replacement command for the S4820T. Replaces the enable xfp-power-
updates command.
8.3.11.4 Replacement command for the Z9000. Replaces the enable xfp-power-
updates command
8.3.10.0 Replacement command for the S4810 only. Replaces the enable xfp-power-
updates command.
Usage
Information
To enable polling and to configure the polling frequency, use this command.
end
Return to EXEC Privilege mode from other command modes (for example, CONFIGURATION or ROUTER OSPF modes).
C9000 Series
Syntax
end
Command Modes
● CONFIGURATION
● SPANNING TREE
● MULTIPLE SPANNING TREE
● LINE
● INTERFACE
● TRACE-LIST
● VRRP
● ACCESS-LIST
● PREFIX-LIST
● AS-PATH ACL
74 Control and Monitoring