Administrator Guide

● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For a Null interface, enter the keywords null 0.
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is 1 to 4096.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
● For a tunnel interface, enter the keyword tunnel then the tunnel ID. The
range is from 1 to 16383.
● For a port extender Gigabit Ethernet interface, enter the keyword peGigE then
the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255;
the stack-unit unit-number range is from 0 to 7; and the port-id range is from 1
to 48.
● For a port extender 10-Gigabit Ethernet interface, enter the keyword
peTenGigE then the pe-id / stack-unit / port-id information. The pe-id range
is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the port-
id range is 25 to 28 or 49 to 52 depending on the PE.
NOTE: The peGigE or peTenGigE option is only visible when the feature
extended bridge feature is enabled.
linecard slot-id Enter the linecard slot-id parameters to specify the switch ports on a line
card. The range of slot IDs is from 0 to 11.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.13.0.1P1 Introduced peTenGigE interface support on the C9010.
9.9(0.0) Introduced on the C9010 and C1048P.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Added support for the tunnel interface type.
9.1(0.0) Updated ManagementEthernet output to include two global IPv6 addresses on
S4810 and Z9000 and added output example showing OpenFlow instance ID.
8.3.12.1 Updated command output to support multiple IPv6 addresses on S4810.
8.3.11.4 Output expanded to support eSR4 optics in Z9000.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.2.1.2 Included SFP and SFP+ optics power detail in the E-Series and C-Series output.
8.2.1.0 Added support for 4093 VLANs on the E-Series ExaScale. Prior releases supported
2094.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Output expanded to include SFP+ media on the C-Series.
7.6.1.0 Introduced on the S Series.
Interfaces 741