Administrator Guide

management egress-interface-selection
To make configured application traffic egress through the management port instead of the front-end (FE) port, enable and
configure a management egress interface.
C9000 Series
Syntax
management egress-interface-selection
To disable and remove management egress interface selection (EIS) configurations, use the no
management egress-interface-selection command.
Defaults None.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the Z9000, S4810, and S4820T.
show ip management-eis-route
Display the management routes used by EIS.
C9000 Series
Syntax
show ip management-eis-route
Defaults None.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.2.(0.0) Introduced on the Z9000, S4810, and S4820T.
Example
Dell# show ip management-eis-route
Destination Gateway State Route Source
----------- ------- ----- ------------
10.11.0.0/16 ManagementEthernet 0/0 Connected Connected
172.16.1.0/24 10.11.192.4 Active Static
786 Interfaces