Administrator Guide

Example
Dell# show management application pkt-fallback-cntr
dns : 0
ftp : 0
ntp : 0
radius : 0
sflow-collector : 0
snmp : 0
ssh : 2
syslog : 0
tacacs : 0
telnet : 0
tftp : 0
Port Channel Commands
A Link Aggregation Group (LAG) is a group of links that appear to a MAC client as if they were a single link according to IEEE
802.3ad. In Dell Networking OS, a LAG is also known as a Port Channel.
● The platform supports 4096 port channels and 16 members per port channel.
Because each port can be assigned to only one Port Channel, and each Port Channel must have at least one port, some of those
nominally available Port Channels might have no function because they could have no members if there are not enough ports
installed.
Port Channel can be configured with port extender (PE) interface when feature extended bridge is enabled.
NOTE:
The Dell Networking OS implementation of LAG or Port Channel requires that you configure a LAG on both switches
manually. For information about Dell Networking OS link aggregation control protocol (LACP) for dynamic LAGs, see the
Link Aggregation Control Protocol (LACP) chapter. For more information about configuring and using Port Channels, see
the Dell Networking OS Configuration Guide.
channel-member
Add an interface to the Port Channel, while in INTERFACE PORTCHANNEL mode.
C9000 Series
Syntax
channel-member interface
To delete an interface from a Port Channel, use the no channel-member interface command.
Parameters
interface (OPTIONAL) Enter any of the following keywords and slot/port, peid/stack-unit/
port-id, or number information:
● For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then
the slot/port information.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a port extender Gigabit Ethernet interface, enter the keyword peGigE then
the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255;
the stack-unit unit-number range is from 0 to 7; and the port-id range is from 1
to 48.
● For a port extender 10-Gigabit Ethernet interface, enter the keyword
peTenGigE then the pe-id / stack-unit / port-id information. The pe-id range
is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the port-
id range is 25 to 28 or 49 to 52 depending on the PE.
788 Interfaces