Administrator Guide

Parameters
number Enter the number of links in a LAG that must be in “oper up” status. The range is
from 1 to 16. The default is 1.
Defaults 1
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.0 Introduced on the E-Series.
Usage
Information
If you use this command to configure the minimum number of links in a LAG that must be in “oper up”
status, the LAG must have at least that number of “oper up” links before it can be declared as up. For
example, if the required minimum is four, and only three are up, the LAG is considered down.
port-channel failover-group
To configure a LAG failover group, access PORT-CHANNEL FAILOVER-GROUP mode.
C9000 Series
Syntax
port-channel failover-group
To remove all LAG failover groups, use the no port-channel failover-group command.
Defaults none
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
792 Interfaces