Administrator Guide

Parameters
adjacency Enter the keyword adjacency so that the restarting router receives the
remaining time value from its peer and adjusts its T3 value so if you have
configured this option.
manual Enter the keyword manual to specify a time value that the restarting router uses.
The range is from 50 to 120 seconds. The default is 30 seconds.
Defaults manual, 30 seconds
Command Modes ROUTER ISIS
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Introduced on the E-Series.
Usage
Information
The running router sets the remaining time value to the current adjacency hold time. You can override this
setting by implementing this command.
Override the default restart-wait time by entering the no graceful-restart restart-wait
command. When you disable restart-wait, the current adjacency hold time is used.
Set the t3 timer to adjacency on the restarting router when implementing this command. The
restarting router gets the remaining time value from its peer and adjusts its T3 value so only when you
have configured graceful-restart t3 adjacency.
Related
Commands
graceful-restart restart-wait — enables the graceful restart maximum wait time before a restarting peer
comes up.
hello padding
Use to turn ON or OFF padding for LAN and point-to-point hello PDUs or to selectively turn padding ON or OFF for LAN or
point-to-point hello PDUs.
C9000 Series
Syntax
hello padding [multi-point | point-to-point]
To return to the default, use the no hello padding [multi-point | point-to-point]
command.
Parameters
multi-point (OPTIONAL) Enter the keywords multi-point to pad only LAN hello PDUs.
point-to-point (OPTIONAL) Enter the keywords point-to-point to pad only point-to-point
PDUs.
Defaults Both LAN and point-to-point hello PDUs are padded.
Command Modes ROUTER ISIS
828 Intermediate System to Intermediate System (IS-IS)